View source for VoIP:Gigaset:Nx70IP

= Introduction =

The purpose of this page is to give information needed to be able to manage Gigaset N870IP and N670IP. VTX is providing full auto configuration of SIP account + DECT Handset configuration. Only the initial pairing of Base station with the DECT Manager and Integrator are needed. Once the final open pairing button is working, all addition of new accounts and DECT phone can be done remotely.


== History ==

* '''2023-11-02''': Opening DECT registration can now be done from the Kiosk, so to add a new SIP account + DECT Handset, you can do everything remotely from the Kiosk. no need to connect on N87x Base Station configuration page. You only need to open registration from Kiosk and map the phone with default PIN 0000 (cf videos)

= Requirements = 

== Documentation ==

* '''Official Manuals''' : https://teamwork.gigaset.com/gigawiki/display/GPPPO/Manuals+-+N870+IP+PRO
* '''Official FAQ N870IP + N670IP''' : https://teamwork.gigaset.com/gigawiki/pages/viewpage.action?pageId=613089809
* '''Change Nx70IP Mode on Reset''': https://teamwork.gigaset.com/gigawiki/display/GPPPO/FAQ+-+Installation
* '''VTX Internal documentation''': https://wiki.interne.smart-telecom.ch/wiki/VoIP:Hardware:Gigaset_N870IP_PRO

== Partner Trainings ==

VTX does provide Partner trainings that are compulsory to follow before working with any Gigaset DECT products. Managing DECT environment is complex: adding too few antennas and you will have coverage and handover problems, adding too much antennas and the cost will go too high

== Gigaset DECT Audit Tools ==

For complex DECT installation, is is compulsory to follow trainings and to use the Gigaset DECT Audit Kit to be able to know where to place antennas



== Video Trainings ==

{{:VoIP:Gigaset:Videos:Nx70IP}}


= Usage =

== How to auto provision a N870IP/N670IP ? - Short Version ==

* '''Problematic''': You wish to auto provision on N670IP + N870IP 
* '''Long Version Solution''': Look at the videos above
* '''Short Version Solution''': Cf below
# '''Kiosk''' - Setup all the SIP + DECT mapping
# '''Base''' : Make sure that the base station is in the correct mode all in one "2 blue icons", cf 1st video
# '''Base''': Reboot it to kick 1st config + Firmware Upgrade (upgrade takes ~10 minutes)
# '''1st Pairing''' : Use https://gigaset-config.com/ to connect to the base station and open DECT registration the 1st time
# '''Other pairing''': Future pairing can be enabled from Kiosk

== How to add a new N870IP/N670IP or Gigaset Handset in the Hardware Module of the customer to allow full auto provisioning ? ==


* '''Problematic''': You would like to have N870IP / N670IP visible in https://kiosk.vtx.ch/VoIP/ManageToIP.aspx customer selfcare
* '''Information''': If the hardware was purchased with VTX, it is automatically added in the system
* '''Solution''': The hardware need to be added by VTX Sales Support Team or by VTX Partners from customer Selfcare Portal


= FAQ = 

{{:FAQ:VoIP:Gigaset:Nx70IP}}